1 / 7
Twisting Container with Hexagonal Screw Cap (NO SUPPORTS) UNDER THREE HOUR PRINT TIME!!!
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Less than 20 grams of filament at 10% infill. No supports needed.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 61
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed both of these in Fusion 360. Print time takes less than 3 hours and only uses 20 grams of filament at 10%. Supports are not needed. Don't resize any smaller (But you can resize bigger). I did a bunch of prints to refine the screw. There is a 0.3 mm tolerance so it will work on almost any printer with no adjustments (I recommend printing at a slower speed though). There is also a 0.15 mm filet on the screw.