1 / 7
Twisting Container with Hexagonal Screw Cap (NO SUPPORTS) UNDER THREE HOUR PRINT TIME!!!
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Less than 20 grams of filament at 10% infill. No supports needed.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 61
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed both of these in Fusion 360. Print time takes less than 3 hours and only uses 20 grams of filament at 10%. Supports are not needed. Don't resize any smaller (But you can resize bigger). I did a bunch of prints to refine the screw. There is a 0.3 mm tolerance so it will work on almost any printer with no adjustments (I recommend printing at a slower speed though). There is also a 0.15 mm filet on the screw.