1 / 4
60mm + 4020 Ender 3 V2 Hotend Fan Shroud
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shroud for a 60mm fan, with a 4020 part cooler blower, made for quiet printing.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 497
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 2)Remiksy (0)Kolekcje (10)Powiązane
I modified a 40mm shroud, so that it can carry 60mm fan with a 4020 blower for part cooling.
DEAD quiet with half the rated fan voltage (the bigger fan manages to cool it on lower RPMs)
Printed with PETG, infill about 70% (its just around the screw holes, the whole shroud is basically filled, if you set your slicer to more than 2 walls)
SCREWS NEEDED:
- Atleast two 35mm M4 screws for the 60mm fan
- Two, atleast 25mm M3 screws for the 4020 blower + exhaust assembly
- One self-tapping screw, issued with the Ender 3 V2 hotend shroud (or any, that fits through the hole on the hotend carriage)