Ugreen DisplayPort/DP switch (CM430) mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows mounting Ugreen DisplayPort switch (CM430) on a flat surface with two screws, e.g., under the table.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed it with 30% infill so that the screw holes are a bit sturdier. Would probably work well with less since the mount is not exposed to a lot of stress/force.
The bottom plate is a bit flimsy at 1mm thickness, but holds well and does not obscure the switch button.
There's a single 0.2mm layer under the screw holes so that it isn't printed in thin air. Thanks to it, supports are not needed. This bridged bit can be simply drilled or pushed through with a screw. Layer height of 0.2mm is therefore recommended.