Ugreen DisplayPort/DP switch (CM430) mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows mounting Ugreen DisplayPort switch (CM430) on a flat surface with two screws, e.g., under the table.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 86
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed it with 30% infill so that the screw holes are a bit sturdier. Would probably work well with less since the mount is not exposed to a lot of stress/force.
The bottom plate is a bit flimsy at 1mm thickness, but holds well and does not obscure the switch button.
There's a single 0.2mm layer under the screw holes so that it isn't printed in thin air. Thanks to it, supports are not needed. This bridged bit can be simply drilled or pushed through with a screw. Layer height of 0.2mm is therefore recommended.