Simple phone or screen mount for 4040 extrusion Android KlipperScreen
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a basic mount for an old android phone to use as clipper screen.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 284
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
For the narrow version, you need one 35 mm M3 screw and one 5 mm M3 heat set insert, then you simply glue or double sided adhesive the phone to the mount.
The wider version is 70 mm wide, in addition to the M3 hardware if you want to use the magnetic mount you will need four 15 mm x 2 mm magnets and four 12 mm x 2 mm magnets.
The reason for the two different sizes is just alignment and so the phone cant slide you have ot lift up to break the magnet.
You could get by with eight of the 12 mm magnets and reley on the magnet for alignment or eight thicker magnets and the phone will just stick up off the mount slightly but stronger connection.
The 4 mm thick allows the phone to sit flush.