Clockwork 2 Single Gear Idler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Single gear idler for Clockwork2
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 419
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Dual gears are not the holy grail, as MirageC and MihaiDesign showed in their videos.
There is always a bit of backlash and usually a single gear can provide enough torque. This is why many modern exruders are now going single gear.
A good example is the Galileo 2, which is superior to the Clockwork2. However, i could never get this to work properly (which i will investigate) and purchased the IDGA gears which are already a huge improvement, especially on vertical walls.
Next to this i wanted to try a single gear, which is this model. This will give a very slight improvement, i think it's noticable for the perfectionist, but be the judge yourself. It's a simple print and doesn't cost much.
BOM
- 2x M3x16 SHCS
- 1x Bearing 693 ZZ (3x8x4mm)
- 1x Voron type heat insert
You might need the do some minor postprocessing to fit the bearing.
I'll take another look to make this a better fit.
Unfortunately you'll need some supports.