CR10/Ender 3 Fanduct for Stock Setup with 40mm fans
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this Fan Duct for any stock Creality CR10 or Ender3 setup, which is inspired by my Fan Duct for the…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 848
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this Fan Duct for any stock Creality CR10 or Ender3 setup, which is inspired by my Fan Duct for the MicroSwiss DirectDrive (https://www.thingiverse.com/thing:4886226) to increase the part cooling capabilities.
.
.
It can be used with a full stock setup as well as the MicroSwiss AllMetalHotend.
.
.
For easy installation and access to the hotend it consists of three parts:
-The main part including the part cooling ducts and backplate
-The removable front fan adapter
-The removable cable guide for cable management
.
.
It uses two 40mm Fans mounted to the sides for part cooling and another 40mm Fan mounted to the front adaptor for cooling the heatbreak/cooling block. All parts are connected with standard M3 screws.
.
.
.
V1 features:
-BLTouch and 18mm probe mount on the front fan adapter (for EZABL,CR10S Probe,...)
-removable cable guide for use with zip-ties
-good ground clearance to avoid hitting bed clips,...
-easily printable with supports set to "Touching Buildplate" in Cura
.
.
I also included some photos for the X- and Y-offsets between the nozzle and BLTouch:
.
BLTouch: define NOZZLE_TO_PROBE_OFFSET {31.98 , -39.13}
18mm Probe: define NOZZLE_TO_PROBE_OFFSET {-32.69 , -45.05}
.
.
If you decide to print the fan duct please consider posting your print as a make or if you did some changes/adjustments or added your own mounts for it, share it as a remix please, so that everybody can profit from it!
Print Settings
Printer Brand:
Creality
Printer:
CR-10
No
Supports:
Yes
0.4mm nozzle, 0.2mm layer height
Infill:
10-25%
Notes:
Supports can be set to "Touching Buildplate" in Cura to reduce the print time!
Category: 3D Printer Accessories