Raspberry Pi 4B Baseplate, 4010 Fan Mount & Beefy DIN Rail Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses 2 DIN rail brackets for a less wobbly installation, adds a baseplate for the Pi 4B, and adds a 4010 fan.
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 174
- Wydruki
- 2
- Wyświetlenia
- 634
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This encases the entire bottom and side of the Raspberry Pi 4 board with an opening on the bottom for easy removal of the microSD card. Utilizes two low profile DIN rail mounting brackets for a sturdier and secure installation of the Pi 4 on the DIN rail. A 3-point 4010 fan mount keeps the Pi 4 cool and the design of the added fan shroud matches Ramalama2's OctoGlasses mod for the Octopus Pro board. Fan shroud has two slits on the side to accommodate the fan cable in both push and pull orientations.
You will need a 3mm drill bit to widen the holes on the Pi4B as the holes are a tad too small for an M3 bolt. STEP file for the baseplate available if you'd like to adjust the design of the case/backplate to use M2 or M2.5 bolts instead.
Standard Voron M3 heatset inserts required for the case, 4010 fan mount, and the din rail mounts. M3 BHCS required for mounting the case onto the din rail mounts.
BOM:
M3 x 5 x 4mm Heatset Inserts x 12 (4 for each - baseplate, fan mount, din mounts)
M3x6 BHCS x 2 (for DIN bracket bottom)
M3x8 BHCS x 2 (for DIN bracket top)
M3x5 Bolt x 1 (for Pi4 mounting to baseplate)
M3x18-20 Bolt x 3 (for 4010 fan bracket)
M3x16 Bolt x 4 (for fan shroud)
Credits for the low profile DIN brackets as well as fan shroud mesh design go to Ramalama2: https://github.com/Ramalama2/Voron-2-Mods/tree/main/DinClips
https://github.com/Ramalama2/Voron-2-Mods/tree/main/Octopus_Pro_FanCase