Voron 1.8 X-Endstop Stealthburner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stealthburner on Voron 1.8 does not reach lower joint with its endstop and I would need to p
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 403
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Stealthburner on Voron 1.8 does not reach lower joint with its endstop and I would need to print whole new lower joint with some spacer reaching to endstop so instead i designed a little bracket that is held with M5 screw that screws into 2020 T-Nut and holds endstop with 2x M3 screw. (you will need 2x M3 heat insert). I also put a little double side tape just to make sure it does not rotate :D
It's around ~7 minute print,
Just make sure that your leadscrew doesnt interfere - mine were just short enough