1 / 7
Magnetic Power Bar /Keyhole Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Inspired by the LTT MCM PBK.... a DIY version
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 554
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Standard Digital File License
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (27)Powiązane
I saw what LTT was doing with their MCM system and thought it would be fun to make a DIY version of the PBK to I could cleanup under my desk. Currently using 2 pairs for a small switch and a power bar.
Printing in PLA provides a bit more of a tight fit and snap in place. ABS or others may require some fine tuning as it felt a touch loose with ABS.
BOM
- QTY 2: M3 Heatset Insert (Length 4.5mm, Voron type)
- QTY1: 20mm countersunk magnet - I purchase “40lb” rated (I used https://tinyurl.com/3v4ep3x9)
- QTY1: M3 Countersunk Screw - 10mm (for magnet)
- QTY 1: M3 Buttonhead Screw - 10mm (for keyhole)
- QTY 3: springs - I used 8mm OD x 10MM length springs (I have a file for 15mm length springs as well, max OD is 9mm)
Assembly
- Insert the heatset inserts into the innie, one on top, one on the bottom
- Place the 3 springs into the circles on the base
- place the innie onto the springs
- Place the Top over the innie and base, press down, turn the Top clockwise until the alignment bumps are lined up
Use
- Place the button head over the keyhole, press the innie down and slide the assembly