Archetype mount adapter for Ender 3 V2 plate (Also Blackbird Bltouch mount and TZ hotend mount)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your Archetype toolhead on the stock Ender 3 V2 mounting plate.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 507
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Ender 3 V2 mounting plate adapter for Archetype (Experimental Branch). Mounting block & holes sized to fit MGN9 rail mounts.
+
BLTouch mount for Blackbird Fan ducts (Short, add spacers for other duct lengths).
(See this post for Mjolnir Medium BLTouch mount)
+
Triangle Labs TZ 2.0 Hotend mount using its two M2.5 mounting holes. Hotend fits short ducts. (Add 1x MZE to fit Medium, and 2x to fit Large (each MZE adds 8.5mm to the meltzone))
Extra BOM:
Adapter Plate:
- 3x M3x6 BHCS
- 1x M3x8 BHCS
- 1x M3 washer
Bltouch mount:
- Swap 2x adapter plate M3x6 BHCS for 2x M3x8 BHCS
- 2x M3 heatsets
- 2x M3x6 BHCS (mounting the bltouch)
TZ Mount:
- 2x M2.5x5 SHCS
External files needed:
- Archetype Core/Rail Mount/MGN9/mgn_left.stl
- Archetype Core/Rail Mount/MGN9/mgn_right.stl
- Archetype - Blackbird/[a]_blackbird_fan_cover.stl
- Archetype - Blackbird/short/blackbird_short_left.stl
- Archetype - Blackbird/short/blackbird_short_left_rear.stl
- Archetype - Blackbird/short/blackbird_short_right.stl
- Archetype - Blackbird/short/blackbird_short_right_rear.stl
- Archetype Core/Extruders/[a]_rear_extruder_bar.stl
- any extruder mount from Archetype Core/Extruders
Probe Offset:
X = 34
Y = -18
Disclaimer/Note:
Clearance between bottom of mounting plate bottom pom wheel and fan splitter spacer is quite tight. This is irrelevant for blackbird short, but if you plan to use a different duct you may want to use a smaller gauge wire