Paper towel holder (Quick swap, no support)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This simple looking papertowel holder makes it easy to keep the paper close but not in the way
- Ocena
- 4,75 / 5
- Polubienia
- 41
- Pobrania
- 282
- Wydruki
- 3
- Wyświetlenia
- 1739
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
This papertowelholder uses a simple print-in-place design. The smaller “pins” you attach to the wall and makes the changing-process easy.
I printed this part using black PETG and a textured buildplate. This creates a cool looking outside.
For the part mounted to the wall I made two versions. One with holes so you can screw it in place (_Part2_V1) and one without holes (_Part2_V2). The later one is the one I'm using. I attach the pieces using doublesided tape.
Print instructions
There are two seperate parts and you will need two of each.
You can find a slicer-ready file where you can mix with the print-settings.
No support is needed for any of the parts.
The parts attached to the wall I prefer to print laying down as in the slice-ready file since this will give the layers the same direction as the coresponding part. The two part will be more smooth to slice on and off.
Suggested settings
Layerheight: 0.2mm
Infill: 10%
Perimeters: 2-3
No support needed
Since these usually don't experience a massive load you should feel free to choose setting suitable for you.
Final notes
Please leave comments and help me improve both as designer and improve this specific detail.