Paper towel holder (Quick swap, no support)
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€6.46 – €7.90 net (excluding VAT)
For file: Papertowelholder_0.2mm_PETG_MK3S_7h9m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €7.18 excluding VAT (range midpoint).
- Weight reported by the author
- 97 g
- Print time reported by the author
- 7.15 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This simple looking papertowel holder makes it easy to keep the paper close but not in the way
- Rating
- 4.75 / 5
- Likes
- 41
- Downloads
- 282
- Makes
- 3
- Views
- 1,744
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
This papertowelholder uses a simple print-in-place design. The smaller “pins” you attach to the wall and makes the changing-process easy.
I printed this part using black PETG and a textured buildplate. This creates a cool looking outside.
For the part mounted to the wall I made two versions. One with holes so you can screw it in place (_Part2_V1) and one without holes (_Part2_V2). The later one is the one I'm using. I attach the pieces using doublesided tape.
Print instructions
There are two seperate parts and you will need two of each.
You can find a slicer-ready file where you can mix with the print-settings.
No support is needed for any of the parts.
The parts attached to the wall I prefer to print laying down as in the slice-ready file since this will give the layers the same direction as the coresponding part. The two part will be more smooth to slice on and off.
Suggested settings
Layerheight: 0.2mm
Infill: 10%
Perimeters: 2-3
No support needed
Since these usually don't experience a massive load you should feel free to choose setting suitable for you.
Final notes
Please leave comments and help me improve both as designer and improve this specific detail.