1 / 1
Dual Fan Mount for i3 MK3S and MK3.5S — zdjęcie 1

Dual Fan Mount for i3 MK3S and MK3.5S

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bracket to mount two 5015 fans to the i3 MK3S and MK3.5S printheads.

Ocena
0 / 5
Polubienia
6
Pobrania
31
Wydruki
0
Wyświetlenia
286
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I wanted to add a dual fan mod to my Prusa i3 MK3s, and liked SadMoney's remix (which now appears to have been removed, so I adapted it to fit an i3 MK3S.

I used M3x20 screws and M3 hex nuts to mount the fans, two M3x8 button head screws for the mount to the extruder body, and for the original fan support (with a square nut). I re-used the original part cooling fan duct screw and square nut.

It'll be easier to mount the bracket/duct to the printhead, then the fans onto it.

Wiring the fans red on red, black on black (in parallel) will have them spin at the same speed. I cut the second fan's wires to length and soldered them onto the original fan's PCB (where the original wires were soldered). Don't solder another yellow wire (signal), one is enough to tell the main-board how fast they are spinning.
The setup is clean and didn't require any unwrapping of the harness. If I want to go back to stock, I simply unsolder the two extra wires and refit the original mounting.

If printing in ABS, I recommend using localized brims for under the corners.

I'm also including the STEP file for those that need to adjust the ducts' height in the model to fit their setup.

Tagi