Ikea lack feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To make my Ikea lack enclosure fit under a shelf above it, i had to lower it. I did this by cutting some length of the…
- Ocena
- 4,952 / 5
- Polubienia
- 170
- Pobrania
- 828
- Wydruki
- 24
- Wyświetlenia
- 4551
- Oceny
- 21
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
To make my Ikea lack enclosure fit under a shelf above it, i had to lower it. I did this by cutting some length of the lower table's legs. This revealed a hollow leg that doesn't look good and could potentially scratch the floor. To fix this issue i made these table leg feet that pressure fit on the legs.
V1: This version has holes for screws.
V2: I found that V1 pressure fit to the legs and didn't need the screws, so I removed the mount.
Installation
Step 1: push the part on the table leg on a 45° angle.
Step 2: rotate the part so that the complete leg is in it, then push down to pressure fit it over the leg
Category: 3D Printer Accessories