1 / 3
28mm Spline Wrench
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I needed a 28mm spline wrench for my milling machine. So, I decided to make one from PLA so that it would break if I forgot to remove it from the drawbar splines.
I printed this as a test with just 15% infill and it was pretty strong. If this breaks, I would probably set the fill to 25-40%.
My machine is pretty well calibrated and this printed for a real snug fit. If your machine is not that well calibrated, I would suggest setting the X-Y Hole compensation values to values that give correct hole sizing on your printer.