WWG2 Nitehawk-36 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
WristWatch-G2 mount for the Nitehawk-36 v1.4+ that is low profile, low weight, and keeps the umbilical at a low height.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 140
- Wydruki
- 1
- Wyświetlenia
- 1155
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I didn't like how bulky the available mounts for the NH-36/WWG2 were, so I made my own. This model is a split design so that features can more easily be printed on both sides. The cord grip is PG-7 threaded.
Print 1x g2_mount and 1x pcb_adapter. If you're using a music wire with your umbilical setup, g2_mount_wire has a small hole/slot to terminate the wire into by inserting, bending to a right angle, then pulling back into the slot.
Hardware required:
- 4x M3x8 BHCS (PCB mounting and motor mount points)
- 2x M3 hex nuts (mount PCB)
- 2x 16mm spacers (motor mount points) - LDO knurled M3 spacers are perfect, or print the ones included in this model (will require 4x heatset inserts)
- 1x M3x35 BHCS (extruder mount point)
Thanks for looking. Leave a make/comment if you use it and any suggestions for improvement if you have them!