Arrma Typhon Clipless Magnetic Body Mounting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are some body mounts I made to eliminate body clips on my Typhon 6s. They are made to fit 3/4" x 1/8"…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 284
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
These are some body mounts I made to eliminate body clips on my Typhon 6s. They are made to fit 3/4" x 1/8" countersunk round magnets. I used ones from K&J Magnetics, which you can get here - https://www.kjmagnetics.com/proddetail.asp?prod=RC22CS-P-N52. The magnets mount to the body with the magnet washers and M4x4 countersunk screws.
These mounts will raise the body by a couple mm so it can clear larger batteries or motor wires.
I have tested these mounts at 106MPH, and I had no issues at all. Off road bashing doesn't seem to be much of a problem either as the magnets usually reseat.
For the front, I placed the magnet directly onto the mounting plate using an M3 screw with a locknut underneath, to keep the front down under high speed. I've included a spacer as well in case you have a very thin magnet or want your entire body to be higher.
Print Settings
Printer Brand:
ELEGOO
Printer:
ELEGOO NEPTUNE 4 Pro
No
Supports:
No
0.20
Infill:
100%
Notes:
Use a brim, otherwise the part may detach during printing.
Category: R/C Vehicles