Arrma Typhon Clipless Magnetic Body Mounting
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are some body mounts I made to eliminate body clips on my Typhon 6s. They are made to fit 3/4" x 1/8"…
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 14
- Makes
- 0
- Views
- 284
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
These are some body mounts I made to eliminate body clips on my Typhon 6s. They are made to fit 3/4" x 1/8" countersunk round magnets. I used ones from K&J Magnetics, which you can get here - https://www.kjmagnetics.com/proddetail.asp?prod=RC22CS-P-N52. The magnets mount to the body with the magnet washers and M4x4 countersunk screws.
These mounts will raise the body by a couple mm so it can clear larger batteries or motor wires.
I have tested these mounts at 106MPH, and I had no issues at all. Off road bashing doesn't seem to be much of a problem either as the magnets usually reseat.
For the front, I placed the magnet directly onto the mounting plate using an M3 screw with a locknut underneath, to keep the front down under high speed. I've included a spacer as well in case you have a very thin magnet or want your entire body to be higher.
Print Settings
Printer Brand:
ELEGOO
Printer:
ELEGOO NEPTUNE 4 Pro
No
Supports:
No
0.20
Infill:
100%
Notes:
Use a brim, otherwise the part may detach during printing.
Category: R/C Vehicles