1 / 5
120mm fan wall for Supermicro SC74X 4U chassis — zdjęcie 1
1 / 5

120mm fan wall for Supermicro SC74X 4U chassis

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 3x120mm fan wall replacing the original sheet metal 4x80mm one in a Supermicro SC742/SC743/SC745/SC748 4U chassis.

Ocena
0 / 5
Polubienia
10
Pobrania
65
Wydruki
2
Wyświetlenia
775
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

A full fan-wall replacement for Supermicro's SC743 SuperChassis; should also work in SC742, SC745, SC748 and other 4U models of this family.

Fully reversibly replaces the factory sheet-metal fan wall without any need for chassis modification. Houses 3 standard 120mm PC fans, compared to factory's 4 80x40mm server fans, allowing for way quieter operation.

Required hardware:

  • 3x 120mm fans (duh) with mounting screws
  • 4x M3 heat-inserts
  • 2x M3 tapered-head screws - for screwing the fan wall on the inside of the chassis, under the lid
  • 2x M3 regular-head screws - for screwing the fan wall from sides of the chassis
  • 2x factory grommets - for cable pass-through
  • recommended: cheap foam tape (e.g. for windows insulation) - to seal against chassis' side-lid
  • recommended: duct tape - to seal against the chassis
  • optional: a piece of plastic or cardboard - to separate out bottom 2 fans and force air through hard drives in the front (see picture #4)

The design includes a raised perimeter intended to act as a brace/stiffener and was designed with ~200x200mm printer beds in mind, thus it's split into 3 parts held together by the fans - yes, the fans are structural. As you can see in the pictures, the fans are pulling the wall slightly into an arc but it still fits the chassis nicely.

Mounting instructions:

  • heat-set the 4 M3 inserts
  • mount a fan to each part (2 screws for side parts, all 4 for center)
  • insert grommets into side parts
  • screw together center and left/bottom parts
  • pull out the original fan wall out
  • pull out the whole 5.25 bay out of the chassis
    • to unlock it simply push on the large blue on top of it
  • put the fan wall in the chassis in a very wide V-shape, align center and right/top parts using the grommet and push the wall to flatness
  • screw the center and right/top parts together through the 5.25 bay opening
  • screw the fan wall to the chassis
  • put the 5.25 bay back in
  • enjoy the silence!

Note: if using with server motherboards, make sure to adjust the fan speed thresholds in BMC/IPMI as 120mm fans will have way lower rotation speeds than 80mm server ones thus triggering an alarm and forcing the fans to run at 100%. For Supermicro's motherboards, see e.g. readme of the SMFC project (I highly recommend using the project itself as well).

Model partially inspired by https://www.printables.com/model/836467-supermicro-cse-743-120mm-fan-wall, but designed from scratch.

The model is admittedly rather crude and probably not very well designed, so feel free to remix and improve it and to brag about it in the comments.

Tagi