500w Daedalus TwoTrees Vacuum Mount Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Moving from the supplied 80w to 500w spindle, the hole spacing was different, so I made this handy adapter.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 213
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
500w vacuum adapter for Daedalus spindle. The vacuum that can be purchased for the TTC450 CNC machine is a must. Link below for the spindle upgrade I used, TwoTrees sells their own, but I already had this spindle. You will also need the adapter plate found on Printables to mount the 500w spindle if using an aftermarket one like I did.
Spindle: https://www.amazon.com/dp/B083VRT6Y3?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1
TwoTrees TTC450 Pro: https://www.twotrees3dofficial.com/products/two-trees-ttc-450-pro-cnc-router-machine
500w Adapter Plate: https://www.printables.com/model/807690-motor-adapter-for-cnc-milling-machine-ttc450
You will need the following minimum hardware (also pictured):
3pc of M4x12mm panhead screws
2pc of M4x16mm panhead screws
3-4pc M4x6mm L heat inserts (the holes in the model could be a little bigger)
Screws in this kit:
https://www.amazon.com/dp/B0DQDH7KLQ?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
Printed with:
0.4mm nozzle, 2mm height, 30% infill, supports on
The holes for the spindle are ever so slightly off… you can tweak the model to your hearts desire.