Phillips Universal Remote SRP2013 CL5 Universal Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Jose Miranda's Airmax Controller Holder, to fit a Phillips SRP2013 CL5 Universal Remote Controller
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Phillips Universal Remote, model SRP2013 CL5 universal mount.
Using the airmax controller file with the rounded geometry that matches my remote, I scaled the original to fit my Phillips remote control snugly. Original interior dims were 57mm x 27mm, but my controller was about ~ 43mm x 17-1/4mm so I scaled the original to approximately 73% and 63%, respectively, for an interior dimensions of 43.23mm & 17.3mm.
When printing with an Ender 3V2 using noctilucent PLA I kept the bed heated only for the initial layers, then turned off bed heating manually. Print density 20% @203degrees C with a brim made a fairly rigid model, but increased density may help for more hazard prone environments. For an idea of adhesion/print strength, the print will likely break @20% infill before it is ripped from the wall with double sided tape.
The original screw holes were kept for future applications, but using double sided tape on the mount is more than sufficient to mount horizontally on a bed frame, without extending past the face of the bed frame.
I didn't bother doing any post processing so it looks a little mediocre, but would look excellent sanded/post processed.