1 / 3
Transformer Re-winding Mandrel 2" x 1.25" x 1.625" — zdjęcie 1
1 / 3

Transformer Re-winding Mandrel 2" x 1.25" x 1.625"

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mandrel for re-winding Output Transformer from Leslie 122 amp. Mounts on 3/8" shaft or 3mm screws to flat plate

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
77
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

Mandrel for re-winding Output Transformer from Leslie 122 valve(tube) amp, or any transformer with 2" x 1 ¼" x 1 5/8" core. Mounts on 3/8" shaft or 3mm screws to flat plate. This could be remixed easily to mount on other coil winding machines but I included a pair of 2.5mm holes threaded to 3mm - each located ¾" from centre - to screw it to a face plate rather than mount on a central spindle. The 3/8" hole might need to be reamed a tad.

Printed in PETG but should work fine with PLA etc. - no supports required if printed with flat mounting face down. 

Tagi