StealthChanger Dragon Burner EBB36 Mount for WWG2 (Wrist Watch G2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stealchanger Dragon Burner EBB36 Mount
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 139
- Wydruki
- 1
- Wyświetlenia
- 1157
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mount for my StealthChange setup. This will fit on a WWG2 with a EBB36, it also clears the OptoTap. There's also a hole for a spring steel support for the umbilical.
You'll need 2 M3 heat insert (Standard Voron M3s M3x5x4mm) to mount the EBB36 to the mount, and 4 M3 heat inserts for the short standoffs (2 for each short standoff). You should be fine with 2 point mounting but i went with 3.
The lower spaces (the 3rd point) dosent need heat inserts just a 30mm M3 screw. Careful to not over tighten!!!
You should use button head screw where the mount connects to the standoffs or it could hit the EBB36, if you using the 3rd mounting point the M3 30mm can be button or socker head.
Been using this mount for a few months and have had ZERO issuesA
If you need anyone help PM me on Discord: JuniorGamingTime
***DISCLAIMER***
You use this mount at your own risk, and i will not be responsible for any hardware damage!