UZI SPRAY GUN

TOMB RAIDER UZI SPRAY GUN important information

At least read this :) The first thing I want to tell you is that before you print make sure that the trigger (only this) has 100% infill! The success of the project depends on it! ok now you can skip the rest of the description and go print :) 

quick video here

DESCRIPTION

Uzi spray gun inspired by tomb raider, the only game used in my sad teenage ahaha :)

Works with any spray can with 32mm attachment, check this before printing.

ASSEMBLY 

Simple and intuitive assembly, you will only need four m4 x 30mm screws and related nuts, black possible (I leave you the link of the ones I purchased here)

The screw holes have been designed to be just tight enough to allow precise alignment of the two halves but at the same time allow the nuts to be tightened (they only slightly self-tap in the hole)

The only thing you have to pay attention to is the direction of positioning of the spring, because it has a specific sense (follow the positioning as indicated in the photo and also in the print file itself)

Don't worry if initially the insertion of the spray can seems too tight because (if you print in PLA) after a few uses the entrance will model itself, I preferred to do it this way because too large a tolerance caused the internal rotation of the can. Obviously I don't need to tell you that you need to be a little careful when inserting and removing the can itself :)

Additional information

In the print file you have the possibility to choose between 2 versions of trigger (rounded or squared) and also some plates with different writings to fix it (use any glue you like) on the sides of the uzi gun, choose the one you prefer.

Good Print :)