1 / 2
Recessed Battop for Sanwa JLF Joystick
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recessed Battop for Sanwa JLF
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 102
- Wydruki
- 1
- Wyświetlenia
- 551
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 4)Remiksy (0)Kolekcje (15)Powiązane
Introduction
This is a battop for Sanwa JLF with a 17.2mm recession. When installed on the normal JLF shaft, it simulates installing the battop on a short shaft. As a balltop enjoyer, I really like this configuration a lot.
This is an idea inspired by folks on the /r/fightsticks Discord.
Future Changes
- None
Printing Suggestions
- 4 Walls / 40% Cubic Infill / No Supports
- 0.1 Layer Height for more detail on the rounded top
- Only tested in PLA/PLA+, but other materials should work.
- Recommend enabling polyholes in Orca Slicer – or equivalent
- I like it with fuzzy skin set to 0.2/0.2
- You may need to make adjustments based on the tolerances of your printer
Assembly
Remove your current balltop and shaft cover. Install the shaft cover with a smaller diameter hole and install this battop. Profit.
Happy Printing!
RAF