fidget spinner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
fidget spinner based on my mini split radial ball bearing, uses 6mm Airsoft BBs
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
Similar to my "mini split radial ball bearing" but with 3 lobes and raised buttons to hold while spinning. I had planned to add a coin or washer in each lobe, but the screws and nuts were enough weight.
This is designed in 4 sections so it can be printed with the raceway of each section facing up for a smooth surface. The ball bearings are assembled between the top an bottom sections so there is no need for a hole and plug.
Assemble with six 6mm Airsoft BBs, three M3x6 socket head screws, one M3x16 socket head screw, and four M3 hex nuts.
I have also included slim versions of the top and bottom inside sections incase anyone prefers a slimmer build. The slim version uses another M3x6 screw rather then the M3x16.
raceway diameter = 13mm
reduced outer diameter from 34mm to 22mm and added 3 lobes with screws
height = 10mm main body or 20mm with center buttons
gap = 0.5 mm
material PLA
print settings: 0.10mm DETAIL
infill = 25% gyroid
seam position = random
bed temp = 70C
model available at: