DJI Goggles V2 Skyzone SteadyView VRX faceplate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows you to mount a Skyzone SteadyView inside your Goggles V2 for an extreemly clean look.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 412
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Model
This is a remix for a Skyzone SteadyView, make sure to look online for instructions on how to do this mod and double check everything before powering it on.
Parts needed
- 1x 5V 500ma plus step down converter that can accept 11.1 to 25.2V.
- 1x Skyzone SteadyView V2.1
- Heatshrink and Kapton tape
Supports:
Print the part upside down with the flat face down on the bed, use tree supports where needed on the edges.
Resolution:
0.10mm
Infill:
30%+
Perimeters:
Ideally 2x plus.
Filament: PETG, PC / PCCF, Nylon or any other sturdy filament.
PLEASE NOTE
If you decide to undertake this modification only you are responsible for any damage, make sure you wire everything up correctly and double check it with a multimeter before powering on the goggles and VRX. Make sure that nothing is shorting and use plenty of heatshrink and Kapton tape.