Thermometer/Hygrometer mount for Prusa CORE One
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A thermometer/hygrometer mount for the Prusa CORE One with (up to) four 6x2.5mm (6x2-3mm) round magnets.
- Ocena
- 4,946 / 5
- Polubienia
- 197
- Pobrania
- 699
- Wydruki
- 38
- Wyświetlenia
- 2619
- Oceny
- 37
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of @Raymond's ‘Hygrometer house for Prusa Core One’ but instead of using the 20x5x2mm or 20x6x2mm magnets this uses (up to*) four 6x2.5mm round magnets (other magnets will work as well, like 2-3mm in height is confirmed working, as long as they are 6mm diameter). The round magnets now sit directly against the metal (and no longer inside the plastic housing) which gives a much stronger hold. *Less than four will probably work fine as well.
The holes for the magnets in the model are 6.1mm and with me I could press fit the magnets in, no glue needed. Otherwise use a small drop of glue (eg. CA) to keep em in there.
There are now two versions, one ‘closed’ and one with 2mm holes behind the magnets so you can push them out more easily later.
The model prints easily without supports, use PETG or ASA/ABS (something that can handle like 60C+), I used 0.2mm layer height and 2 walls with 15% infill.
(As expected the temps are pretty much the same as the on screen chamber temps, but I needed something I could see and check from further away in the garage; this works great).