1 / 3
HDM-K1,K1C,K1SE,K1A left motor mount for CFS — zdjęcie 1
1 / 3

HDM-K1,K1C,K1SE,K1A left motor mount for CFS

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The motor mounting model is suitable for HDM K1(hdm-utah), adjustments may be needed for the rest of the lineup.

Ocena
0 / 5
Polubienia
17
Pobrania
60
Wydruki
0
Wyświetlenia
931
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Attention!! I do not know the distances from the back wall to the new silicone brush and the plastic drop-off point when CFS replacing filament. At the moment, I can assume that for the modifications with rails, it will be necessary to model and print a different version of the plastic drop-off point, because the original carriage is 23mm wide, while the rail modifications (BCJ, HDM, Kemsky) are 14mm wider than the original carriage.

 

A simplified model for mounting a new part called 'cutter block' for K1 Series printers. If you have installed full linear Rails from hdm-utah mod,and want to buy CFS with K1 Series Kit, this part is really necessary for you. The model is still in development; I haven't received my CFS yet

For the former belt tensioner use 4x M3 Voron Brass nuts(M3*OD5*L4) to secure the cutter block. Use 2x(or 4x) stock m3x16 shcs screws 


 

Tagi