UNC 3/8" to Hot Shoe Joint for Microphone Arm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hot shoe adapter/joint for mounting hot shoe accessories to a 3/8" UNC thread - e.g. a microphone to a microphone arm
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
This is an adapter I made to connect my Røde Videomic Go II with a hot shoe mount to the Røde microphone arm using a 3/8" UNC thread.
It includes a joint with a thumbscrew to adjust the angle of the microphone.
Printing Instructions
Hot Shoe Model
Print on side, with the hot shoe opening facing upwards (as seen on picture).
Thumb Screw
Print on base (as seen on picture).
Important: Add a pause to the print at 13.6mm to drop in the hex nut.
Thread Side
Print on side of thread (as seen on picture). This ensures the compressive forces act perpendicular to the layers.
Required Hardware
- 1 M6x30-35 hex head bolt
- 1 M6 hex nut
Assembly
- Remove the bridging layer from the thumb screw (e.g. with a 6mm drill or by just pushing the bolt through)
- Slide the thread side print into the hot shoe side
- Push the M6 bolt through the center hole
- Screw on the thumb screw