1 / 5
Deluxe Paint/Condiment Cup Organizer - Free Spinning - 24 capacity — zdjęcie 1
1 / 5

Deluxe Paint/Condiment Cup Organizer - Free Spinning - 24 capacity

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A free spinning organizer for small condiment cups using a 5x200mm carbon fiber rod and 608 bearings.

Ocena
0 / 5
Polubienia
3
Pobrania
9
Wydruki
0
Wyświetlenia
96
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

This should work for any standard size 1oz condiment cups. Around this size. I included the original blender project file, and if you're familiar with it can be fairly easily edited for other cup sizes (active modifiers are only on the first tier shelf). I use them for paints but could be used for other things such as agar cups. It fits 24 cups.

Hardware

Assembly

Print List
  • 1x coupler-13.6mm : For 1st tier
  • 2x coupler-21.1mm: For 2nd and 3rd tiers
  • 3x shelf
  • 1x base
  • 1x top-cap

Basic print settings work fine (20% infill, 0.2mm layer height). I used 0.12mm for the couplers for a bit of extra strength.

Notes
  1. Mark the rod at 96mm and 173.6mm from the bottom before inserting it into the base making sure it goes all the way down. You can give it a light tap with a hammer if needed. You may consider using a little glue for more strength when moving it around.
  2. Snap the bearings onto all the couplers, then install the small one flat onto the base and tighten down the coupler with the m3 bolt and nut.
  3. Repeat the same for the other two shelves, lining the bottom of the couplers to the marks. Then just simply slip on the top cap (There should be at least a small amount of space between the top shelf and the cap).

~Couplers were made from these

Tagi