1 / 5
Deluxe Paint/Condiment Cup Organizer - Free Spinning - 24 capacity
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A free spinning organizer for small condiment cups using a 5x200mm carbon fiber rod and 608 bearings.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 9
- Makes
- 0
- Views
- 96
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
This should work for any standard size 1oz condiment cups. Around this size. I included the original blender project file, and if you're familiar with it can be fairly easily edited for other cup sizes (active modifiers are only on the first tier shelf). I use them for paints but could be used for other things such as agar cups. It fits 24 cups.
Hardware
- 1x 5x200mm carbon fiber rod
- 3x 608 bearings (skateboard bearings)
- 3x m3-16mm bolts
- 3x m3 nuts
Assembly
Print List
- 1x coupler-13.6mm : For 1st tier
- 2x coupler-21.1mm: For 2nd and 3rd tiers
- 3x shelf
- 1x base
- 1x top-cap
Basic print settings work fine (20% infill, 0.2mm layer height). I used 0.12mm for the couplers for a bit of extra strength.
Notes
- Mark the rod at 96mm and 173.6mm from the bottom before inserting it into the base making sure it goes all the way down. You can give it a light tap with a hammer if needed. You may consider using a little glue for more strength when moving it around.
- Snap the bearings onto all the couplers, then install the small one flat onto the base and tighten down the coupler with the m3 bolt and nut.
- Repeat the same for the other two shelves, lining the bottom of the couplers to the marks. Then just simply slip on the top cap (There should be at least a small amount of space between the top shelf and the cap).
~Couplers were made from these