1 / 4
X-Sense XC01-M CO alarm adapter for magnetic mount — zdjęcie 1
1 / 4

X-Sense XC01-M CO alarm adapter for magnetic mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter plate to easily mount the carbon monoxide sensor to ceilings/walls using adhesive magnetic plates.

Ocena
5 / 5
Polubienia
4
Pobrania
24
Wydruki
1
Wyświetlenia
120
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a simple and quick-to-print adapter plate for the X-Sense XC01-M Carbon Monoxide (CO) sensor alarm for anyone wishing to mount it to the ceiling/wall using those common magnet mounts that have a metal plate on the wall/ceiling and a magnetic plate on the device you're mounting (In case sticking with magnets and adhesive is easier than drilling).

 

The alarm is normally attached using two screws that the device slides on to but since I already had a metal plate hanging from the previous alarm and also didn't want to make holes into the ceiling I decided to over-engineer some simple mount because the device has an uneven back side with model numbers etc. on it so I figured sticking the magnet wouldn't be the best idea.

 

The main part is simply put onto the sensor and the two locking pins/bits can then be sled into the gap that remains. Otherwise, the sensor might fall off if someone would touch it while attached to the ceiling or so.

This way, the mount never falls off and the even and large back side allows for the magnet to stick to it. 

 

Removing the two pins is simple by just pulling them out using your fingers - they slightly stick out which should be fine in all cases because the magnet mount adds spacing so that the pins shouldnt touch the ceiling. Otherwise, you may just scale their height (Z) down a bit. 

 

Just make sure not to accidentally turn it around when assembled as the tiny pins are no tight fit, they will fall out and be gone forever ;)

 

I printed it using “snug” supports for the top parts that have overhangs. With a bit of care they are easily removed. If not, its just about 8g of filament. Noone gets hurt.

Feel free to improve the design, my goal was reached so I didn't improve it further.

It works, that was my goal :D

Tagi