Schluter Thermostat Bezel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bezel for Schluter DITRA-HEAT-E-RS1, possibly more.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
I purchased a Schluter DITRA-HEAT-E-RS1 thermostat for the heated floor in my bathroom to replace the stock non-wifi one. When I installed it, I noticed that it was slightly smaller than the original unit and did not completly cover the drywall opening and looked a bit unsightly. I designed this up in Fusion 360 in about 15 minutes and gave it a shot. It worked wonderfully with a very clean look. Nothing fancy; I used eSun HS PLA at a 0.2mm layer height and 20% gyroid infill on a Voron 2.4. For extra neatness, I used a textured PEI bed and a single perimeter for the first layer. This could very well work on other things as it uses standard receptacle sizing. Includeding the STEP file in case you need to adjust.