1 / 9
Honda Element Roof Rail Solar Connector Adapter for OEM Roof Rack Rails — zdjęcie 1
1 / 9

Honda Element Roof Rail Solar Connector Adapter for OEM Roof Rack Rails

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Roof rail adapter to run power to or from the roof exterior of the OEM roof rack rails on the good ol' Honda Element.

Ocena
0 / 5
Polubienia
4
Pobrania
24
Wydruki
0
Wyświetlenia
467
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

Solar Power Connector Adapter for Honda Element Roof Rack Rails – This compact, aerodynamic adapter slides onto a single rail and positions the connector facing the rear for streamlined power integration. Durable and lightweight solution.

Printed in gray PETG at 0.2mm layer height with 3 wall layers and 25% infill, this piece takes approximately 5 hours to print while consuming around 57 grams of material. Supports are used to enhance both post-processing efficiency and overall strength.

The connector type I'm using for this build is an XT60H-M and connected two 100W solar panels to two of these adapters. Ran the power cable under the top rear fender towards the hatch door power cable, 1 bolt and tabs in the fender to mind. Then down the driver's side rear pillar but inside the hatch area to behind the driver's side taillight, 2 screws. There's a little rubber washer that I popped out, and drilled a hole to run the power cables through to the inside of the frame. Inside you have to remove several screws from the lower side plastic panel on the other side of the taillight, pry the panel about 6" open to reach and fish the cables around until your hand finds them. Only glue, seal, and secure after you are sure where you would like your cables.

Feel free to tweak any details as needed!

Tagi