Ratcheting Torque Wrench for Nozzle by Bondtech
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ratcheting Torque Wrench for 1/4" sockets and Hex bits by Bondtech
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 45
- Wydruki
- 1
- Wyświetlenia
- 305
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
Important Note : this model is not my creation, but I did not find the equivalent here so I share my printing profiles as could be usefull
When using an interchangeable nozzle on the printer, we need to be careful with the torque applied when tightening the nozzle to prevent any damage on the aluminium thread (Bondtech specify a maximum of 1.5N.m)
You also need to take in account that the nozzle will be hot when swapped (220°C) so the use of a socket is nearly mandatory to not burn you finger, and let the nozzle could down when taken aside
I was making my own model of a knob to adapt it to a standard ¼" socket, and while searching for the maximum torque values I found this model by Bondtech. They advertise a maximum torque of 1.5N.m so I printed several “stars” and took an industrial quality torque wrench to test those materials :
- PLA (SILK and standard)
- PLA+
- PETG
Each measure showed a torque of less than 1N.m so this design will be safe for the thread, no matter what filament you have on hand.
It is also ratcheting on the other side which is nice at use!
It is composed of 2 main elements :
- 1 body in 2 parts with clips to remain closed, and can be reopened later (green part below)
- a “star” with a choice of interface : ¼" square (black part) or ¼" Hexagonal (grey part)
You can mix and match (PLA body with PETG star for exemple, which is my final choice…), there will be no difference.