Charging port cover Version 3 for the Renault 5 e-tech

Since we plan to always have the car connected to the wallbox when not in use, we wanted a cover. This will provide additional protection for the charging port from rain and snow.
To prevent the cover from scratching the paint, we are printing the cover in TPU 95A. For the locking mechanism, like the original cover, we are using an ASA insert. This is simply pressed in. This should be clearly visible in the pictures.

Caution: Place the insert that the slot is vertical and fits to lock at the car.

The upper slope in the pictures doesn't look good. This isn't due to the model, but rather to my ability to print TPU with support. In the model file, this surface is flat.

This is version 3, which covers the charging port opening and the opening for the release button. The hinge of the cover is also better sealed.

Two other versions can be found here:

• Version 1 Charging port cover for the Renault 5 e-tech von Stefan Gerber | Kostenloses STL-Modell herunterladen | Printables.com
• Version 2 Charging port cover Version 2 for the Renault 5 e-tech by Stefan Gerber | Download free STL model | Printables.com which covers the charging port opening only

Printing instructions
For the R5_chargeport_cover_V3.stl use TPU 95A the get some flexibility and to prevent scratches:

• 0.2mm layer height, with less I couldn't remove the support material
• printed with support over 30° and on build plate only
• 6 wall loops to make the walls solid

For the R5_chargeport_cover_lock.stl use a hard filament like PETG or ASA:

• use hard filament
• 0.16mm layer height
• no support
• 5 wall loops to make the walls solid