1 / 2
Voron Trident Nozzle brush, poop bucket and flexplate aligner — zdjęcie 1
1 / 2

Voron Trident Nozzle brush, poop bucket and flexplate aligner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

All in one piece, poop bucket is attached with magnets to make it easy to empty.

Ocena
5 / 5
Polubienia
37
Pobrania
256
Wydruki
1
Wyświetlenia
1275
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

All in one solution for nozzle brush, flex plate stop/alignment and poop bucket. 

I designed it primarily for use with TAP where the nozzle is barely able to reach brushes since TAP pushes the nozzle forward. So i positioned the brush right on the edge of the bed. 

Check the Z distance between the top of your bed and the top of the brush holder.  I included both step and Fusion file if you want to change the height if its too high/low. You want it to be just high enough so the flexplate hits it. If it sticks up too much you might run into problem if your scanner hits it.

BOM:

1x Bambu mini clone silicone brush. Available on aliexpress, amazon…

6x 6x3mm neodynium magnets

2x M3 T-nuts/Hammerhead nuts

2x M3x8mm BHCS screw to attach it to the 

Installation instructions:
Flame and/or clean the brush area before attaching the brush to make it stick better.
Glue the magnets in place with some super glue

 

Tagi