1 / 2
Retro Arcade Stick
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An arcade stick that fits my P1S print bed with a retro look
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 169
- Wydruki
- 3
- Wyświetlenia
- 852
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (9)Wydruki i komentarze (Wydruki: 3) (Komentarze: 3)Remiksy (0)Kolekcje (47)Powiązane
What you need :
- Buttons, stick and controller like this one https://www.amazon.fr/dp/B01HJKLAV6?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1
- M3 brass inserts https://www.amazon.fr/dp/B0BZVGQ91H?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2
- M3 screws https://www.amazon.fr/dp/B09BJFM8W4?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3
Description :
This model is 250 x 150 x 47 mm so it fits my Bambu P1S print bed.
I was inspired by the design of the 8BitDo Arcade Stick.
I used the Textured PEI Plate for the top and bottom parts and the 3D Effect Carbon Fiber Plate for the buttons base.
If you don't want to make a multicolor model there is a file for that (Arcade-stick_top-full)
Printing :
I used basic print settings with a 0.4mm nozzle and 0.2mm layer height with supports and brim activated. It is a little less than 300g and around 8hours of printing.
Assembly :
- Print the top part and remove the supports.
- With a soldering iron, place the inserts. There are 4 for holding the stick and 7 more to close the box.
- Print the buttons base.
- Snap it into the top part, it should be enough but you can glue it if you want.
- Screw the stick in place.
- Insert the buttons.
- Connect everything to the controller board.
- Screw the bottom part and add small non-slip pads for better grip
- And voilà ! That's it, enjoy