1 / 2
Retro Arcade Stick
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An arcade stick that fits my P1S print bed with a retro look
- Rating
- 0 / 5
- Likes
- 42
- Downloads
- 171
- Makes
- 3
- Views
- 862
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
What you need :
- Buttons, stick and controller like this one https://www.amazon.fr/dp/B01HJKLAV6?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1
- M3 brass inserts https://www.amazon.fr/dp/B0BZVGQ91H?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2
- M3 screws https://www.amazon.fr/dp/B09BJFM8W4?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3
Description :
This model is 250 x 150 x 47 mm so it fits my Bambu P1S print bed.
I was inspired by the design of the 8BitDo Arcade Stick.
I used the Textured PEI Plate for the top and bottom parts and the 3D Effect Carbon Fiber Plate for the buttons base.
If you don't want to make a multicolor model there is a file for that (Arcade-stick_top-full)
Printing :
I used basic print settings with a 0.4mm nozzle and 0.2mm layer height with supports and brim activated. It is a little less than 300g and around 8hours of printing.
Assembly :
- Print the top part and remove the supports.
- With a soldering iron, place the inserts. There are 4 for holding the stick and 7 more to close the box.
- Print the buttons base.
- Snap it into the top part, it should be enough but you can glue it if you want.
- Screw the stick in place.
- Insert the buttons.
- Connect everything to the controller board.
- Screw the bottom part and add small non-slip pads for better grip
- And voilà ! That's it, enjoy