1 / 4
PROPTOP: Core One Magnetic Cover [Now Open Source!] — zdjęcie 1
1 / 4

PROPTOP: Core One Magnetic Cover [Now Open Source!]

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A magnetic top cover for the Core ONE, including print-in-place hinged legs for extra airflow or extended maintenance.

Ocena
0 / 5
Polubienia
44
Pobrania
66
Wydruki
0
Wyświetlenia
1782
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

UPDATE: 07/07/2025: I have decided not to continue forwards with developing this design further myself, however I do believe it has some potential use, therefore I have added all of the source files, please feel free to use them as you wish!

---------------------------------------------------------------------------------------------------------

 

ORIGINAL DESCRIPTION:

This modification requires 10 small bar magnets (10*5*2mm - no affiliation), with space for an additional 8 if the magnetic force is not strong enough. The magnets should slide into the slots and stay there with friction - a spot of glue will ensure they never break free if this is an issue. Remember to insert the two magnets at the end of the legs. Each of the magnet slots are twice as long as they need to be, allowing for a second magnet to be inserted if using just one is too weak. You will also need 8 M3x10mm self-tapping screws. 

You will need one of each printed part, with the exception of the side piece - 2 of these should be printed. All of the files should be in the correct orientation for printing. No supports are needed, except for a small section at the top of the Slide. The two side hinges are print-in-place. Give it a few movements after printing to loosen it up and ensure it moves freely.

The rest of the assembly should be relatively straightforward. I have included a tolerance test to ensure your screws and magnets fit properly before committing to printing everything.

Since I haven't attached a hinge to the back of the panel, you will need to wedge it against the raised edge at the rear of the printer during use. The two legs should swing out and secure themselves with their magnets to the inner lip of the printer's top surface. Simply push them away, and they should fold back to allow the panel to be reset.

 

----------------------------------------------------------------------------------------------------------------

This remixs borrows heavily from dteng's original cover, thank you for sharing and allowing for modification :)

Tagi