270° door hinge for Infimech TX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An articulated 270 degree door hinge for the Infimech TX
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 39
- Wydruki
- 1
- Wyświetlenia
- 357
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
A small upgrade for the Infimech TX/Flying Bear S1. It's an articulated hinge that allows the door to swing open to the side of the machine.
You will need:
• 8 x M3x10 screws and 8 x M3 nuts, 4 screws and nuts per hinge
• 4 x 2mm pins 50mm long (about 2 inch) , 2 per hinge.
You will need to do 2 prints pauses. If you print with .2 height, you will need to pause at layer 36 and 84 and place the nuts.
The 2mm pins I sourced from 2mm welding rods. In don't know how the thing on the rods its called but you can clean it with pliers by gently squeezing them and breaking it away.
After the print is done to install the pins, put the big part of the hinge on its side, place the two small articulation pieces in their slots and with a hammer carefully install the first pin, for the second one take the smaller part of the hinge and install the pin in the same manner.
I printed them in PLA and they are plenty strong for the weight of the door.
Printing:
5 or 6 walls
>50% gyroid infill
Use the STL and print as is.
I included the STEP file also.