1 / 5
The Wattson - The Rivian Magsafe Charging Dock (Personal Use)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An angled and forward mounted phone charger that supports MagSafe charging and still uses the Granola Tray.
- Ocena
- 0 / 5
- Polubienia
- 2
- Wydruki
- 0
- Wyświetlenia
- 178
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Standard Digital File License
- Unhappy with the factory wireless charger, I found some third part options to not be viable either. I looked at the s00nish printable plate, but I disliked the location it put my phone in as I couldn't see the bottom third while charging. I got to work designing my own and decided to elevate the phone mount, angle it to clear the wood grain lip, and I made sure to put in the “Granola Tray”. It ended up looking a bit like a smiley face so I named it Wattson! It is printable on most printers with minimal supports required and only on non visible faces to prevent any visible scaring. I did end up purchasing the s00nish step down charger found here. (non affiliated link)
- It uses the Anker MagSafe Pucks x2 found here. (affiliate link)
- I highly recommend this purchase for the charger as it allows you to use the factory plug for the original wireless charger, freeing up both console USB-C slots. I intend to add a version that allows you to pass through the two USB-C cables for anyone that doesn't want to add the step-down converter.
- The accent rings can be printed separate and snap into place to allow a very clean finished face on the top.
- The granola tray should snap into place as well as the angled mounts, but I put some CA glue on them to be certain.
- My favorite part of this design is the use of 1.75 TPU filament to secure it. There are two holes around the lip with a 2mm channel. Tie a knot in some TPU, fish it through the hole and loop the channel. Then just fish it back inside the other hole and pull it tight to tie another knot to secure it. This provides a very solid friction fit that keeps it in place unless you want to remove it.
- Multicolor on any printer as the parts are printed separately and assembled.
Assembly and Install Video
- This version is intended for individual use only and is NOT TO BE SOLD!!!