SAAB 9-3 Passenger side center console handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement part for the SAAB 9-3 passenger side center console handle. Snaps in place. (Smart slot cover)
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 118
- Wydruki
- 1
- Wyświetlenia
- 506
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Replaces the passenger side handle on the SAAB 9-3 center console. This is only the top part that snaps into place with no screws needed. Should fit all 2nd generation 9-3s.
Printed on an Ender 3 V2 Neo
Printable vertically with no supports if using a dimensionally stable material like PETG.
0.24mm layer height, 3-4 perimeters and 15% infill. Adding a brim in your slicer is also recommended (See image)
For materials that shrink significantly (PCTG, ABS, ASA, etc.) an enclosure is necessary. PLA prints fine too, but it will eventually deform or melt in the car in hotter climates.
Tested on a 2010 SAAB 9-3. The clips are quite snug and the part is a bit difficult to remove so be careful. Modelled after the original part to replicate it as closely as possible.
Please share any feedback so I can improve the part in the future! Thanks!