Switchwire / Enderwire Rollover Handles and Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rollover feet and top stand or handles to safely tip an Enderwire or other 2020 Switchwire over for service.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 349
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
I promised to cad this up ages ago and as soon as I actually started rebuilding my enderwire I actually did it. Inspired by RockAndRoll for the 2.4, you can tip an open or enclosed Enderwire on its side and and it will be stable.
Yes my desk is a mess. But my switchwire is complete-ish.
The handles protrude just as far as the rocker feet and top stand so can be used instead of the top stand and the screw spacing is 150mm +/- 2.5mm matching that of the Dark_dog Enderwire enclosure.
You'll need to figure out how not to drop T-nuts when installing the enclosure, I'd recommend slide in rather that twist in or roll in t-nuts if you plan on using the handles to carry the printer, maybe use a second slide in nut beneath, secured with a set screw?
My handles are ABS printed to voron-ish specs, 4 walls, 5 perimeters, 0.2mm layers, 0.44ish lines in PrusaSlicer (0.4 forced is for cura and is old advice, prusaslicer does the flow maths differently), 40% gyroid infill (0.6mm width) and they are plenty strong. Make sure you print them as oriented.
The rollover feet prototypes have been fine in PLA. They have recesses for the panels so double as panel clips.
Handles need M5x16 BHCS, Feet and sidestand need M5x40 BHCS or SHCS screws. All from my Voron spares.
Was inspired by this but couldn't directly adapt it
https://mods.vorondesign.com/details/tiIhFDTh9tHJY0JNJK9A