Petsafe Dog Door Cover Replacement With A Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Why is the new door compliant claws retention instead of a pin or something???
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 171
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update 11-13-25: Added a super long handle variant that makes the handle go as long as the prusa XL build plate.
A printed door replacement for the Petsafe door system, but with a pin retention like the old door model and a handle for setups where a cage gets in the way of normal pin setups.
https://www.amazon.com/PetSafe-Entry-Telescoping-Tunnel-Medium/dp/B079QPL57P/
Hardware-
1 https://www.mcmaster.com/98330A115/ pin cut down to the 2nd hole. There is a picture showing what this means.
1 short pin to retain the cap on (it has to fit inside the pin hole). I would glue this pin in after you have found the correct spring that doesn't jam.
1 spring that wraps around the pin (3/16 id minimum and has a wire thickness that is not too small to jam into the holes of the pin while sliding past the door housing. ( I don't have a specific spring, but the spring should not be super strong.)
- The pin head should be glued to the end of the pin or it will not stay on correctly.
-If you have a color changing printer, you can change the infill and it will show that color in the light if your door is not dark like the picture. (Prusament White and Neon Green).