1 / 8
Mountainbike rear thru axle mount (157 x 12 mm and 148 x 12mm) inkl. axle chain holder — zdjęcie 1
1 / 8

Mountainbike rear thru axle mount (157 x 12 mm and 148 x 12mm) inkl. axle chain holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

if you need your bike without your wheels for transporting, cleaning or anything.

Ocena
0 / 5
Polubienia
5
Pobrania
27
Wydruki
0
Wyświetlenia
155
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Nice rear frame/axle mount for your bike, incl. a chain holder - think its self explaining.

update 1: you are now able to use it frontside2front or backside2front - both sides have the M4 insert drills for the chainholder.

update 2: made it stronger

update 3: drillhole arrangement for 4040 aluminum profiles

update 4: added 101% scaled Versions to ASA/ABS folder

 

The BOM:

4x or more  M8 screws incl. big or small washers (depend on which drillholes you use)

1x axle (157 x 12mm or 148 x 12mm)

1x or 2x Ruthex M4/M4S Inserts

1x M4 20mm hexhead screw

1x dirty bike with a desperate sticky chain

1x too long bike for your car with a mounted rear wheel

1x truck, car, trailer which is too short :-) or cargo area, service area

1x approx. 13cm Riser to save the pulley cage from the ground (i am working on one) - or you use a aluminium 8020 or 8040 to mount the fork holder and the rear axle holder. (messure your wheelbase - I had round about 127cm so ordered a 140cm profile.

 

Assembling needs a little bit of sanding depending on your choosen filament, if you want to keep them in the mount dont sand to much, if you want them flying around in the car on the working days - sand much more :-)

 

Print settings:

  • minimum 6 walls, infill gyroid minimum 40% (ASA/ABS/PC/PCTG)
  • in the screw area you could use some modifier to get more infill in the sensible zones (look at the fork mount to have a clue)
  • i have used some dummy primitives (yellow) around the axle hole (1 wall/5%) and also one in the axle, its also possible a brim would be enough (have a look onto the picture) keep enough distance otherwise the dummies are bonded to your mount
  • when using ASA or ABS dont forget to use +1% scaling in XY (added a folder with 101% models)
  • best would be to test the tolerances via the adapter for your filament with a test print
                              ###dont forget to mount the wheels when going for a ride ###

Tagi