1 / 11
New mounting for RC gravity scale from hobbyking
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Since I did not like the suspension and mounting (is quite a fumble)
On the picture you can see the front of the new, in the back the original suspension.
Just remove the chrome pins from the wood and put the new holder over it and screw it tight.
You can print two different holders. If you use the original sliding caliper, plug a piece of silicone tube in the ball bearing for distance.
Ball bearing is used. 5mm thick, 5mm axis, 11mm outside diameter.
Print Settings
Printer Brand:
Anet
Printer:
A6
Doesn't Matter
Supports:
Doesn't Matter
0,3
Infill:
20%
Category: R/C Vehicles